IEEE 1017.4-2023
$37.92
IEEE Recommended Practice for Testing and Rating of Electrical Submersible Pump Motors (Approved Draft)
Published By | Publication Date | Number of Pages |
IEEE | 2023 | 49 |
New IEEE Standard – Active. Procedures and test values for testing and rating of electrical submersible pump (ESP) motors as well as installation and handling practices are specified in this document. The specified procedures and test values apply to ESP motor systems rated 3kV through 8kV (phase to phase).
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | IEEE Std 1017.4™-2023 Front cover |
2 | Title page |
4 | Important Notices and Disclaimers Concerning IEEE Standards Documents |
8 | Participants |
10 | Introduction |
12 | Contents |
14 | 1. Overview 1.1 Scope 1.2 Purpose 1.3 Word usage |
15 | 2. Normative references 3. Definitions |
18 | 4. Electrical measurements 4.1 General 4.2 Power supply used for electrical measurements |
19 | 4.3 Instrument selection 4.4 Instrument transformers 4.5 Voltage 4.6 Current 4.7 Power 4.8 Resistance |
20 | 5. Mechanical measurements 5.1 Mechanical-output measurement methods 5.2 Brake 5.3 Dynamometer 6. General considerations 6.1 Environmental influences |
21 | 6.2 Test equipment |
22 | 6.3 Equipment setup 6.4 Special fault-locating test equipment |
23 | 6.5 Equipment maintenance 7. Motor model and design parameters 7.1 Basic data |
25 | 8. Routine tests 8.1 Terminal/stator winding resistance |
26 | 8.2 Insulation resistance test 8.3 Surge comparison test 8.4 Phase rotation 8.5 Hipot test 8.6 Factory acceptance test (idle test/no load test) |
27 | 8.7 String test |
28 | 8.8 Machine vibration measurements 9. Motor design performance tests 9.1 Basis of tests 9.2 Load test |
31 | 9.3 Tests with rotor locked 9.4 Correction to a specified temperature |
32 | 10. Efficiency tests 10.1 Applicable test standards 10.2 Types of losses |
35 | 11. Surge comparison testing 11.1 Turn-turn insulation failures |
36 | 11.2 Description 11.3 Test conditions |
37 | 11.4 High frequency test levels for new coils |
38 | 12. DC hi-pot test methods 12.1 Overview 12.2 Precautions 12.3 DC high potential tester (hi-pot) |
39 | 12.4 Equipment setup 12.5 Procedures |
40 | 12.6 Evaluation of dc hi-pot test results 13. Vibration analysis and dynamic balancing 13.1 General |
41 | 13.2 Vibration reduction |
42 | 14. Motor expected design life (thermal insulation rating) testing 14.1 Insulation aging concepts |
43 | 14.2 Limiting temperatures and their measurements for EIS |
44 | 14.3 Temperature classes of EIS |
45 | 15. Characteristics of connected drives |
47 | Annex A (informative) Bibliography |
49 | Back cover |