1.1 This test method provides dc hysteresigraph procedures ( B-H<\/i> loop methods) for the determination of basic magnetic properties of materials in the form of ring, toroidal, link, double-lapped Epstein cores, or other standard shapes that may be cut, stamped, machined, or ground from cast, compacted, sintered, forged, or rolled materials. It includes tests for normal induction and hysteresis taken under conditions of continuous sweep magnetization. Rate of sweep may be varied, either manually or automatically at different portions of the curves during tracing. Total elapsed time for tracing a hysteresis loop is commonly 10 to 120 s per loop.<\/p>\n
1.2 The values stated in either customary (cgs-emu and inch-pound) units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the systems may result in nonconformance with this test method.<\/p>\n
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.<\/i><\/p>\n
| PDF Pages<\/th>\n | PDF Title<\/th>\n<\/tr>\n | ||||||
|---|---|---|---|---|---|---|---|
| 1<\/td>\n | Scope Referenced Documents Summary of Test Method <\/td>\n<\/tr>\n | ||||||
| 2<\/td>\n | Significance and Use Interferences FIG. 1 <\/td>\n<\/tr>\n | ||||||
| 3<\/td>\n | FIG. 2 TABLE 1 <\/td>\n<\/tr>\n | ||||||
| 4<\/td>\n | Apparatus Test Specimens for Ring-Type Measurements Test Specimens for Permeameter Measurements <\/td>\n<\/tr>\n | ||||||
| 5<\/td>\n | Calibration of Integrator(s) Calibration of Magnetizing Circuit Calibration of Data Recorder Procedure TABLE 2 <\/td>\n<\/tr>\n | ||||||
| 7<\/td>\n | Calculations When Using Permeameter Procedures Report When Using Permeameter Procedures <\/td>\n<\/tr>\n | ||||||
| 8<\/td>\n | Precision and Bias When Using Permeameter Procedures Calculations When Using Ring Test Procedures <\/td>\n<\/tr>\n | ||||||
| 9<\/td>\n | Report When Using Ring Test Procedures Precision and Bias When Using Ring Test Procedures Keywords X1. SYMMETRICAL HYSTERESIS LOOPS WITH D-C ELECTRONIC HYSTERESIGRAPHS X1.1 General X1.2 Manual Procedure <\/td>\n<\/tr>\n | ||||||
| 10<\/td>\n | X1.3 REFERENCES <\/td>\n<\/tr>\n<\/table>\n","protected":false},"excerpt":{"rendered":" A773\/A773M-01 Standard Test Method for dc Magnetic Properties of Materials Using Ring and Permeameter Procedures with dc Electronic Hysteresigraphs<\/b><\/p>\n |