ISO 2851:1993
$12.35
Stainless steel bends and tees for the food industry
| Published By | Publication Date | Number of Pages |
| ISO | 1993-06 | 12 |
Specifies the dimensions, tolerances, surface roughness, materials and hygienic requirements. The bends and tees are intended to be used with stainless steel tubes specified in ISO 2037.
Related products
-
ISO 2859-1:1999/Amd 1:2011
Sampling procedures for inspection by attributes — Part 1: Sampling schemes indexed by acceptance quality…
-
BS EN ISP 10613-7:1997:1995 Edition
Information technology. International standardized profile RA. Relaying the connectionless-mode network service – PSDN subnetwork-dependent, media-dependent…
-
ISO 2852:1993
Stainless steel clamp pipe couplings for the food industry Published By Publication Date Number of…
-
BS EN 28510-1:1993:1991 Edition
Adhesives. Peel test for a flexible-bonded-to-rigid test specimen assembly – 90° peel Published By Publication…
-
ISO 2881:1992
Tobacco and tobacco products — Determination of alkaloid content — Spectrometric method Published By Publication…
-
ISO 2853:1993
Stainless steel threaded couplings for the food industry Published By Publication Date Number of Pages…
-
BS ISO/IEC 9548-1:1996:1997 Edition
Information technology. Open systems interconnection. Connectionless session protocol – Protocol specification Published By Publication Date…
-
ISO 2751:1973
Urea for industrial use — Determination of the buffer coefficient — Potentiometric method Published By…
-
ISO 2857:1973
Ground thread taps for ISO metric threads of tolerances 4H to 8H and 4G to…
-
ISO 2850:1973
Potassium sulphate for industrial use — Determination of loss of mass at 105 degrees C…
-
ISO 2801:1998
Clothing for protection against heat and flame — General recommendations for selection, care and use…
-
BS 7967-4:2007
Carbon monoxide in dwellings and the combustion performance of gas-fired appliances – Guide for using…
-
ISO 2857:1973/Amd 2:1986
Ground thread taps for ISO metric threads of tolerances 4H to 8H and 4G to…
-
CAN/CSA-ISO/IEC 9805-1-04 (R2014):2004 Edition
Information Technology – Open Systems Interconnection – Protocol for the Commitment, Concurrency and Recovery Service…
-
BS 6400-1:2006
Specification for installation, exchange, relocation and removal of gas meters with a maximum capacity not…
-
ISO 2859-0:1995
Sampling procedures for inspection by attributes — Part 0: Introduction to the ISO 2859 attribute…
-
ISO 9851:1990
Continuous mechanical handling equipment — Overhead electrical monorail conveyors — Definitions and safety rules Published…
-
ISO 2821:1974/Amd 1:1996
Leather — Raw hides of cattle and horses — Preservation by stack salting — Amendment…
-
BS 5081-1:1994
Sterile hypodermic syringes and needles – Specification for sterile, single-use hypodermic syringes for manual use…
-
BS 1673-2:1967
Methods of test for raw rubber and unvulcanized compounded rubber – Chemical analysis of raw…
-
ISO 2857:1973/Amd 1:1984
Ground thread taps for ISO metric threads of tolerances 4H to 8H and 4G to…
-
BS EN ISO 2871-2:1994
Surface active agents. Detergents. Determination of cationic-active matter content – Cationic-active matter of low molecular…
-
BS 6001-3:1993
Sampling procedures for inspection by attributes – Specification for skip-lot procedures Published By Publication Date…
-
BS EN 28510-2:1993:1991 Edition
Adhesives. Peel test for a flexible-bonded-to-rigid test specimen assembly – 180° peel Published By Publication…
-
BS 3762-3-3.4:1991:1992 Edition
Analysis of formulated detergents – Quantitative test methods. – Method for determination of lower molecular…
-
ISO 2859-1:1999
Sampling procedures for inspection by attributes — Part 1: Sampling schemes indexed by acceptance quality…
-
BS EN ISO 4894-1:1999
Plastics. Styrene/acrylonitrile (SAN) copolymer moulding and extrusion materials – Designation system and basis for specifications…
-
BS EN ISO 2871-1:1994
High molecular mass cationic-active matter Published By Publication Date Number of Pages BSI 1994 10
-
ISO/IEC 9805-1:1998
Information technology — Open Systems Interconnection — Protocol for the Commitment, Concurrency and Recovery service…
-
BS EN ISP 10607-2:1997
Information technology. International standardized profiles AFTnn. File transfer, access and management – Definition of document…
-
BS ISO/IEC 9594-7:1990:1991 Edition
Information technology. Open systems interconnection – Selected object classes Published By Publication Date Number of…
-
ISO 7851:1983
Matières fertilisantes — Classification Published By Publication Date Number of Pages ISO 1983-10 11
-
ISO 2831:1973
Sodium fluoride for industrial use — Determination of water-insoluble matter Published By Publication Date Number…
-
AS 1199.1:2003 (R2016)
Sampling procedures for inspection by attributes – Sampling schemes indexed by acceptance quality limit (AQL)…
-
ISO 2251:1991
Lined antistatic rubber footwear — Specification Published By Publication Date Number of Pages ISO 1991-12…
-
BS EN ISO 7051:1995
Specification for cross-recessed raised countersunk (oval) head tapping screws Published By Publication Date Number of…
-
BS EN 27501-1:1993
Identification cards. Machine readable travel documents – Machine readable passport Published By Publication Date Number…
-
BS 2451:1963
Specification for chilled iron shot and grit Published By Publication Date Number of Pages BSI…
-
BS EN 12049:1997
Solid fertilizers and liming materials. Determination of moisture content. Gravimetric method by drying under reduced…
-
ISO 2451:1973
Cocoa beans — Specification Published By Publication Date Number of Pages ISO 1973-12 8
