BS ISO 3548-2:2020
$102.76
Plain bearings. Thin-walled half bearings with or without flange – Measurement of wall thickness and flange thickness
| Published By | Publication Date | Number of Pages |
| BSI | 2020 | 18 |
This document specifies in accordance with ISO 12301 the checking of the wall-thickness of thin-walled half bearings with or without flange and describes the necessary checking methods and measuring equipment.
It applies to a maximum bearing diameter of 150 mm. It can be applied to a bigger diameter, provided that there is an agreement between the supplier and the user.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 2 | National foreword |
| 6 | Foreword |
| 7 | 1 Scope 2 Normative references 3 Terms and definition |
| 8 | 4 Symbols and units 5 Purpose of checking |
| 9 | 6 Checking methods 6.1 Measuring principle of wall thickness 6.2 Line measurement around the circumference |
| 10 | 6.3 Line measurement in axial direction |
| 11 | 6.4 Point measurement |
| 13 | 6.5 Grading of bearings 6.6 Eccentric bore 6.7 Measuring principle for flange thickness |
| 14 | 6.8 Measuring point for flange thickness 7 Requirements for measuring equipment and specimen for the contact method 7.1 Tip-radius for measuring pin on the outside surface 7.2 Tip-radius for measuring pin on the inside surface 7.3 Measuring pin load 7.4 Set-up 7.5 Periodical control |
| 15 | 7.6 Measurement failures on the inside and/or outside surface 8 Checking of measuring equipment |
| 16 | Bibliography |
