BS EN ISO 17140:2016
$142.49
Fine ceramics (advanced ceramics, advanced technical ceramics). Mechanical properties of ceramic composites at room temperature. Determination of fatigue properties at constant amplitude
| Published By | Publication Date | Number of Pages |
| BSI | 2016 | 24 |
This International Standard specifies the conditions for the determination of properties at constant-amplitude of load or strain in uniaxial tension/tension or in uniaxial tension/compression cyclic fatigue of ceramic matrix composite materials (CMCs) with fibre reinforcement at room temperature.
This International Standard applies to all ceramic matrix composites with fibre reinforcement, unidirectional (1D), bi-directional (2D), and tri-directional (xD, where 2 < x ≤ 3).
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 4 | European foreword |
| 6 | Foreword |
| 7 | Section sec_1 Section sec_2 Section sec_3 Section sec_3.1 Section sec_3.1.1 1 Scope 2 Normative references 3 Terms and definitions 3.1 General |
| 8 | Section sec_3.1.2 Section sec_3.1.3 Section sec_3.1.4 Section sec_3.1.5 Section sec_3.1.6 Section sec_3.1.7 |
| 9 | Table tab_a Figure fig_1 Section sec_3.2 Section sec_3.2.1 Section sec_3.2.1.1 3.2 Cyclic fatigue phenomena |
| 10 | Section sec_3.2.2 Section sec_3.2.2.1 Section sec_3.2.2.2 Section sec_3.2.2.3 Section sec_3.2.2.4 Section sec_3.2.3 Section sec_3.2.3.1 Section sec_3.2.3.2 Section sec_3.2.3.3 Section sec_3.2.3.4 Section sec_3.2.4 Section sec_3.2.4.1 |
| 11 | Section sec_3.2.4.2 Section sec_3.2.4.3 Section sec_4 Section sec_5 4 Principle 5 Significance and use |
| 12 | Table tab_b Figure fig_2 Section sec_6 Section sec_6.1 Section sec_6.2 6 Apparatus 6.1 Fatigue test machine 6.2 Load train |
| 13 | Section sec_6.3 Section sec_6.4 Section sec_6.5 Section sec_7 6.3 Extensometer 6.4 Data recording system 6.5 Micrometers 7 Test specimens |
| 14 | Figure fig_3 Table tab_1 Section sec_8 Section sec_8.1 Section sec_8.2 Section sec_9 Section sec_9.1 8 Test specimen preparation 8.1 Machining and preparation 8.2 Number of test specimens 9 Test procedure 9.1 Measurement of test specimen dimensions |
| 15 | Section sec_9.2 Section sec_9.2.1 Section sec_9.2.2 Section sec_9.2.3 Section sec_9.3 9.2 Testing technique 9.3 Test validity |
| 16 | Section sec_10 Section sec_10.1 Section sec_10.2 Section sec_10.3 10 Calculation of results 10.1 Time to failure, tf 10.2 Damage parameters 10.3 Residual properties |
| 18 | Table tab_e Figure fig_4 Section sec_11 11 Test report |
| 20 | Annex sec_A Table tab_f Figure fig_A.1 Annex A (informative) Schematic evolution of E |
