BS EN 17009:2019
$167.15
Flooring of lignified materials other than wood. Characteristics, assessment and verification of constancy of performance and marking
| Published By | Publication Date | Number of Pages |
| BSI | 2019 | 44 |
This European Standard defines and specifies the relevant characteristics, requirements and appropriate test methods for determination of the suitability of floorings made with at least a top layer of lignified material other than wood for use as internal flooring including in fully enclosed public transport premises. The European Standards for specific flooring products made of lignified material other than wood to which this European Standard applies, and which provide product definitions, requirements for dimensional tolerances and other technical specifications, are the following: – Bamboo flooring products (EN YYYYY), – Palm flooring products (EN ZZZZZ). This European Standard provides also for the assessment and verification of constancy of performance and the requirements for marking these products. This European Standard covers flooring products made of lignified material other than wood which may or may not be treated to improve their reaction to fire performance or their durability against biological agents. This European Standard does not apply to: – flooring products specifically manufactured for enhanced tactile and recognition, – wood flooring products covered by EN 14342, – laminate flooring products covered by EN 14041.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 2 | National foreword |
| 6 | European foreword |
| 7 | Introduction |
| 8 | 1 Scope 2 Normative references |
| 9 | 3 Terms and definitions |
| 14 | 4 Symbols and abbreviations 4.1 Symbols 4.2 Abbreviations |
| 15 | 5 Flooring products characteristics 5.1 Reaction to fire 5.2 Dangerous substances 5.2.1 Content of dangerous substances 5.2.2 Emission of dangerous substances into indoor air |
| 16 | 5.3 Bending and breaking strength 5.3.1 General 5.3.2 Test methods and results 5.4 Slip resistance 5.5 Thermal properties (resistance) 5.5.1 General 5.5.2 Testing |
| 17 | 5.5.3 Calculation |
| 18 | 5.6 Biological durability 5.6.1 General 5.6.2 Biological durability testing 5.7 Other characteristics 5.7.1 Raw materials 5.7.2 Moisture content 5.7.3 Hardness |
| 19 | 5.7.4 Bonding 5.7.5 Dimensional tolerances 6 Attestation and verification of constancy of performance 6.1 General 6.2 Type Testing 6.2.1 General |
| 20 | 6.2.2 Test samples, testing and compliance criteria 6.2.3 Test reports 6.2.4 Shared other party results |
| 21 | 6.3 Factory production control (FPC) 6.3.1 General 6.3.2 Requirements |
| 24 | 6.3.3 Product specific requirements 6.3.4 Initial inspection of factory and of FPC |
| 25 | 6.3.5 Continuing surveillance, assessment and evaluation of FPC 6.3.6 Procedure for modifications 6.3.7 One-off products, pre-production products (e.g. prototypes) and products produced in very low quantity |
| 26 | 7 Marking, labelling and packaging |
| 27 | Annex A (normative) Declaration of formaldehyde emission |
| 29 | Annex B (normative) Biological durability testing of products made of lignified material other than wood |
| 34 | Annex C (normative) Raw materials |
| 36 | Annex D (normative) Moisture content |
| 37 | Annex E (normative) Dimensional tolerances |
| 42 | Bibliography |
