BS EN 15048-2:2016 – TC:2020 Edition
$134.27
Tracked Changes. Non-preloaded structural bolting assemblies – Fitness for purpose
| Published By | Publication Date | Number of Pages |
| BSI | 2020 | 35 |
This European Standard specifies the technical requirements for structural bolting assemblies in order to ensure the suitability for non-preloaded bolted connections in steel structures or aluminium structures. A suitability test is specified to check the behaviour of the structural bolting assemblies. It applies to bolting assemblies specified in FprEN 15048-1.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 21 | Contents Page |
| 22 | European foreword |
| 23 | Introduction |
| 24 | 1 Scope 2 Normative references |
| 25 | 3 Terms and definitions 4 Symbols 5 Technical requirements for bolting assemblies 5.1 Composition of structural bolting assemblies 5.2 Product requirements |
| 26 | 5.3 Manufacturing process 5.3.1 Material 5.3.2 Nuts 5.3.3 Bolts 5.3.4 Finish and coating 5.4 Marking 5.4.1 Bolts |
| 27 | Figure 1 — Example of bolt marking 5.4.2 Nuts Figure 2 — Example of nut marking |
| 28 | 5.4.3 Washers 5.5 Delivery conditions 6 Tensile test of bolting assemblies for determination of tensile resistance 6.1 Principle 6.2 Test conditions 6.2.1 General 6.2.2 Test apparatus |
| 29 | 6.2.3 Test assemblies 6.2.4 Test set-up Figure 3 — Typical test set-up 6.2.5 Test procedure 6.3 Required failure mode |
| 30 | 6.4 Required tensile resistance 7 Test report |
| 31 | Annex A (informative) Special testing conditions and procedures |
| 32 | Bibliography |
