ASTM-A592 2010

$35.75

A592/A592M-10 Standard Specification for High-Strength Quenched and Tempered Low-Alloy Steel Forged Parts for Pressure Vessels

Published By	Publication Date	Number of Pages
ASTM	2010	3

Guaranteed Safe Checkout

Categories: 23.060.01 - Valves in general, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM A592/A592M-10

Historical Standard: Standard Specification for High-Strength Quenched and Tempered Low-Alloy Steel Forged Parts for Pressure Vessels

ASTM A592/A592M

Scope

1.1 This specification covers high-strength quenched and tempered low-alloy steel forged parts for pressure vessels. The maximum thickness of forgings under this specification shall be 1½ in. [38 mm] for Grade A, and 4 in. [100 mm] for Grades E and F.

Note 1—These grades are similar to corresponding grades in Specification A517/A517M.

1.2 Although no provision is made for supplementary requirements in this standard, the supplementary requirements in Specification A788/A788M may be considered by the purchaser.

1.3 Welding technique is of fundamental importance and it is presupposed that welding procedures will be in accordance with approved methods for the class of material used.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 Unless the order specifies the applicable “M” specification designation, the material shall be furnished to the inch-pound units.

Keywords

high-strength low-alloy steel; pressure vessel service; quenched and tempered steel; steel forgingsalloy; Carbon steel forgings–specifications; Pressure vessel steel forgings–specifications; Steel fittings–specifications

ICS Code

ICS Number Code 23.060.01 (Valves in general)

DOI: 10.1520/A0592_A0592M-10

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Ordering Information and General Requirements Materials and Manufacture
2	Heat Treatment Chemical Requirements Mechanical Requirements TABLE 1 TABLE 2 TABLE 3
3	Repair Welding Test Reports Product Marking Keywords

Additional information

Standard Title	A592/A592M-10 Standard Specification for High-Strength Quenched and Tempered Low-Alloy Steel Forged Parts for Pressure Vessels
Published Code	ASTM
Publication Date	2010
Pages Count	3
ICS Codes	23.060.01 - Valves in general