{"id":380782,"date":"2024-10-20T03:08:27","date_gmt":"2024-10-20T03:08:27","guid":{"rendered":"https:\/\/pdfstandards.shop\/product\/uncategorized\/bs-en-iec-613162021\/"},"modified":"2024-10-26T05:41:12","modified_gmt":"2024-10-26T05:41:12","slug":"bs-en-iec-613162021","status":"publish","type":"product","link":"https:\/\/pdfstandards.shop\/product\/publishers\/bsi\/bs-en-iec-613162021\/","title":{"rendered":"BS EN IEC 61316:2021"},"content":{"rendered":"
This document applies to cable reels provided with a non-detachable flexible cable with a rated operating voltage not exceeding 690 V DC and\/or 690 V AC with a frequency not exceeding 500 Hz and a rated current not exceeding 63 A, primarily intended for industrial use, either indoors or outdoors, for use with accessories complying with IEC 60309\u20111, IEC 60309\u20112 or IEC 60309\u20114.<\/p>\n
This document applies to:<\/p>\n
portable cable reels equipped with one plug or appliance-inlet complying with IEC 60309\u20111 or IEC 60309\u20112 and at least one socket-outlet complying with IEC 60309\u20111, IEC 60309\u20112 or IEC 60309\u20114;<\/p>\n<\/li>\n
fixed cable reels equipped with at least one socket-outlet complying with IEC 60309\u20111, IEC 60309\u20112 or IEC 60309\u20114;<\/p>\n<\/li>\n
cable reels suitable for use at ambient temperature normally within the range of \u221225 \u00b0C to +40 \u00b0C.<\/p>\n<\/li>\n<\/ul>\n
The use of this equipment on construction sites and for agricultural, commercial and domestic appliances is not precluded.<\/p>\n
This document also applies to cable reels intended to be used in extra-low voltage installations.<\/p>\n
In locations where special conditions prevail, for example, on board ships, in vehicles and the like, or where explosions are liable to occur, additional requirements can be necessary.<\/p>\n
\nNOTE 1 This document was not developed for Electric Vehicle (EV) application, but it can be used as guide for cable reels for EV application<\/p>\n<\/blockquote>\n
\nNOTE 2 Additional requirements for cable reels for currents higher than 63 A are under consideration.<\/p>\n<\/blockquote>\n
PDF Catalog<\/h4>\n
\n
\n PDF Pages<\/th>\n PDF Title<\/th>\n<\/tr>\n \n 2<\/td>\n undefined <\/td>\n<\/tr>\n \n 5<\/td>\n Annex ZA (normative)Normative references to international publicationswith their corresponding European publications <\/td>\n<\/tr>\n \n 7<\/td>\n English
CONTENTS <\/td>\n<\/tr>\n\n 9<\/td>\n FOREWORD <\/td>\n<\/tr>\n \n 11<\/td>\n 1 Scope
2 Normative references <\/td>\n<\/tr>\n\n 12<\/td>\n 3 Terms and definitions <\/td>\n<\/tr>\n \n 15<\/td>\n Figures
Figure 1 \u2013 Pillar terminals
Figure 2 \u2013 Screw terminals
Figure 3 \u2013 Stud terminals <\/td>\n<\/tr>\n\n 16<\/td>\n Figure 4 \u2013 Saddle terminals
Figure 5 \u2013 Lug terminals
Figure 6 \u2013 Mantle terminals <\/td>\n<\/tr>\n\n 17<\/td>\n Figure 7 \u2013 Screwless terminals
Figure 8 \u2013 Insulation piercing terminals <\/td>\n<\/tr>\n\n 18<\/td>\n 4 General requirements
5 Standard ratings
Tables
Table 1 \u2013 Preferred rated currents <\/td>\n<\/tr>\n\n 19<\/td>\n 6 Classification
7 Marking <\/td>\n<\/tr>\n\n 21<\/td>\n 8 Dimensions
9 Protection against electric shock
Figure 9 \u2013 Test piston <\/td>\n<\/tr>\n\n 23<\/td>\n Figure 10 \u2013 Standard 1 mm gauge <\/td>\n<\/tr>\n \n 24<\/td>\n 10 Provisions for earthing
10.1 Accessible metal parts
10.2 Corrosion resistance of earth terminal
10.3 Corrosion resistance of screws and nuts
10.4 Earth connections <\/td>\n<\/tr>\n\n 25<\/td>\n 10.5 Internal earthing circuit
10.6 Internal moveable earth connection and slip rings <\/td>\n<\/tr>\n\n 26<\/td>\n 11 Terminals and terminations
11.1 Common requirements for terminals and terminations <\/td>\n<\/tr>\n\n 28<\/td>\n 11.2 Screw type terminals <\/td>\n<\/tr>\n \n 29<\/td>\n Figure 11 \u2013 Gauges for testing insertability of round unprepared conductors <\/td>\n<\/tr>\n \n 30<\/td>\n 11.3 Screwless type terminals <\/td>\n<\/tr>\n \n 32<\/td>\n Figure 12 \u2013 Information for the bending test <\/td>\n<\/tr>\n \n 33<\/td>\n Table 2 \u2013 Deflection test forces <\/td>\n<\/tr>\n \n 34<\/td>\n 11.4 Insulation piercing terminals (IPT) <\/td>\n<\/tr>\n \n 35<\/td>\n 11.5 Mechanical tests on terminals <\/td>\n<\/tr>\n \n 36<\/td>\n Figure 13 \u2013 Test arrangement for terminals
Table 3 \u2013 Pulling test values on terminals <\/td>\n<\/tr>\n\n 37<\/td>\n 11.6 Voltage drop test for screwless type terminals and for insulation piercing terminals
Table 4 \u2013 Pulling force <\/td>\n<\/tr>\n\n 39<\/td>\n 11.7 Tests for insulation piercing terminals transmitting contact pressure via insulating parts
11.7.1 Temperature-cycling test
11.7.2 Short-time withstand current test
12 Resistance to ageing of rubber and thermoplastic material
Table 5 \u2013 Test current <\/td>\n<\/tr>\n\n 40<\/td>\n 13 Construction <\/td>\n<\/tr>\n \n 42<\/td>\n 14 Degrees of protection <\/td>\n<\/tr>\n \n 43<\/td>\n 15 Insulation resistance and dielectric strength <\/td>\n<\/tr>\n \n 44<\/td>\n 16 Normal operation
Table 6 \u2013 Test voltage for dielectric strength test <\/td>\n<\/tr>\n\n 45<\/td>\n 17 Temperature rise
17.1 Temperature rise in normal use <\/td>\n<\/tr>\n\n 46<\/td>\n Table 7 \u2013 Permissible temperature rise <\/td>\n<\/tr>\n \n 47<\/td>\n 17.2 Temperature rise under overload conditions <\/td>\n<\/tr>\n \n 48<\/td>\n 18 Flexible cables and their connection <\/td>\n<\/tr>\n \n 49<\/td>\n Table 8 \u2013 Minimum cable sizes
Table 9 \u2013 Maximum length of cable <\/td>\n<\/tr>\n\n 51<\/td>\n 19 Mechanical strength <\/td>\n<\/tr>\n \n 52<\/td>\n 20 Screws, current-carrying parts and connections
Table 10 \u2013 Gland tightening force <\/td>\n<\/tr>\n\n 53<\/td>\n Table 11 \u2013 Tightening torques <\/td>\n<\/tr>\n \n 55<\/td>\n 21 Creepage distances, clearances and distances through sealing compound
Table 12 \u2013 Creepage distances, clearances and distances through sealing compound <\/td>\n<\/tr>\n\n 57<\/td>\n 22 Resistance to heat, to fire and to tracking <\/td>\n<\/tr>\n \n 58<\/td>\n 23 Corrosion and resistance to rusting <\/td>\n<\/tr>\n \n 59<\/td>\n 24 Electromagnetic compatibility
24.1 Immunity
24.2 Emission <\/td>\n<\/tr>\n<\/table>\n","protected":false},"excerpt":{"rendered":"Industrial cable reels<\/b><\/p>\n
\n\n
\n Published By<\/td>\n Publication Date<\/td>\n Number of Pages<\/td>\n<\/tr>\n \n BSI<\/b><\/a><\/td>\n 2021<\/td>\n 62<\/td>\n<\/tr>\n<\/tbody>\n<\/table>\n","protected":false},"featured_media":380792,"template":"","meta":{"rank_math_lock_modified_date":false,"ep_exclude_from_search":false},"product_cat":[513,2641],"product_tag":[],"class_list":{"0":"post-380782","1":"product","2":"type-product","3":"status-publish","4":"has-post-thumbnail","6":"product_cat-29-120-99","7":"product_cat-bsi","9":"first","10":"instock","11":"sold-individually","12":"shipping-taxable","13":"purchasable","14":"product-type-simple"},"_links":{"self":[{"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/product\/380782","targetHints":{"allow":["GET"]}}],"collection":[{"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/product"}],"about":[{"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/types\/product"}],"wp:featuredmedia":[{"embeddable":true,"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/media\/380792"}],"wp:attachment":[{"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/media?parent=380782"}],"wp:term":[{"taxonomy":"product_cat","embeddable":true,"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/product_cat?post=380782"},{"taxonomy":"product_tag","embeddable":true,"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/product_tag?post=380782"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}