ASTM-D8444/D8444M 2024

$34.13

D8444/D8444M-24 Standard Specification for Fiber Reinforced Polymer Dowel Bars for Load Transfer Between Concrete Slabs

Published By	Publication Date	Number of Pages
ASTM	2024

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D8444/D8444M-24

Active Standard: Standard Specification for Fiber Reinforced Polymer Dowel Bars for Load Transfer Between Concrete Slabs

ASTM D8444/D8444M

Scope

1.1 This specification covers glass fiber reinforced polymer (GFRP) dowel bars, provided in cut lengths and having a smooth surface so that when embedded in concrete, the expansion and contraction of concrete along the longitudinal axis of the dowel is not inhibited. A dowel bar, commonly referred to as a dowel, acts as a shear transfer device between concrete slabs. In addition, GFRP dowel bars are electromagnetically transparent, lightweight compared to steel, and non-corroding. Dowels covered by this specification shall meet the requirements for geometric, material, mechanical, and physical properties described herein.

1.2 Dowel bars produced according to this standard must meet the requirements using the test methods referenced in Table 1. Quality control and acceptance of production lots of dowel bars must meet the requirements using the test methods referenced in Table 2.

1.3 The text of this specification references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables) shall not be considered as requirements of the specification.

1.4 The following dowel bars are not covered by this specification:

1.4.1 Dowel bars made of more than one load-bearing fiber reinforcement type (that is, hybrid FRP).

1.4.2 Dowel bars having an external surface treatment, coating or bond-breaking agent added after production.

1.4.3 Dowel bars having an external surface enhancement for bonding with concrete (that is, bars intended for concrete reinforcement).

1.4.4 Dowel bars with geometries other than solid, round cross sections.

1.5 This specification is applicable for either SI (as Specification D8444M) or inch-pound units (as Specification D8444).

1.6 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.6.1 Within the text, the inch-pound units are shown in brackets.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

corrosion resistant dowel bar; dowel bars for concrete street and highway pavement; GFRP dowel bar; GFRP load transfer; non-metallic dowel bar;

ICS Code

ICS Number Code n/a

DOI: 10.1520/D8444_D8444M-24

Additional information

Standard Title	D8444/D8444M-24 Standard Specification for Fiber Reinforced Polymer Dowel Bars for Load Transfer Between Concrete Slabs
Published Code	ASTM
Publication Date	2024