🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
ASTM-A268/A268M 2016

ASTM-A268/A268M 2016

$40.63

A268/A268M-10(2016) Standard Specification for Seamless and Welded Ferritic and Martensitic Stainless Steel Tubing for General Service

Published By Publication Date Number of Pages
ASTM 2016 7
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

ASTM A268/A268M-10-Reapproved2016

Historical Standard: Standard Specification for Seamless and Welded Ferritic and Martensitic Stainless Steel Tubing for General Service

ASTM A268/A268M

Scope

1.1 This specification2 covers a number of grades of nominal-wall-thickness, stainless steel tubing for general corrosion-resisting and high-temperature service. Most of these grades are commonly known as the “straight-chromium” types and are characterized by being ferromagnetic. Two of these grades, TP410 and UNS S 41500 (Table 1), are amenable to hardening by heat treatment, and the high-chromium, ferritic alloys are sensitive to notch-brittleness on slow cooling to ordinary temperatures. These features should be recognized in the use of these materials. Grade TP439 is used primarily for hot-water tank service and does not require post-weld heat treatment to prevent attack of the heat affected zone.

(A) For small diameter or thin walls, or both, tubing, where many drawing passes are required, a carbon maximum of 0.015 % is necessary. Small outside diameter tubes are defined as those less than 0.500 in. [12.7 mm] in outside diameter and light wall tubes as those less than 0.049 in. [1.2 mm] in average wall thickness (0.040 in. [1 mm] in minimum wall thickness).
(B) Plate version of CA6NM.
(C) Carbon plus nitrogen = 0.30 max.
(D) Nickel plus copper.
(E) Carbon plus nitrogen = 0.025 % max.
(F) Cb/(C + N) = 12 min.

1.2 An optional supplementary requirement is provided, and when desired, shall be so stated in the order.

1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound units shall apply unless the “M” designation of this specification is specified in the order.

Keywords

ferritic stainless steel; seamless steel tube; stainless steel tube; steel tube; welded steel tube;

ICS Code

ICS Number Code 23.040.10 (Iron and steel pipes)

DOI: 10.1520/A0268_A0268M-10R16

ASTM-A268/A268M 2016
$40.63