BS EN 10365:2017
$167.15
Hot rolled steel channels, I and H sections. Dimensions and masses
| Published By | Publication Date | Number of Pages |
| BSI | 2017 | 38 |
This European standard specifies the nominal dimensions and masses of the hot rolled steel channels, I and H sections.
The following shapes are covered by this standard:
Sections:
-
Parallel flange I sections IPE;
-
Wide flange beams HE;
-
Extra wide flange beams HL and HLZ;
-
Wide flange columns HD;
-
Wide flange bearing piles HP and UBP;
-
Universal beams UB;
-
Universal columns UC;
-
Taper flange I sections IPN and J.
Channels:
-
Parallel flange channels UPE and PFC;
-
Taper flange channels UPN, U and CH.
These requirements do not apply to hot rolled steel channels, I and H sections from stainless steel.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 4 | Contents Page |
| 5 | European foreword |
| 6 | 1 Scope 2 Normative references |
| 7 | 3 Terms and definitions 4 Designation 5 Dimensions and masses Figure 1 — IPE, HE, HL, HD, HP, UBP, UB and UC parallel flange sections |
| 8 | Figure 2 — Taper flange I sections IPN, J and extra wide flange beams HLZ Figure 3 — Parallel flange channels UPE and PFC Figure 4 — Taper flange channels UPN, U and CH |
| 9 | 6 Tolerances on dimensions, shape and mass 7 Material |
| 10 | Table 1 — Parallel flange I sections IPE |
| 13 | Table 2 — Wide flange beams HE |
| 18 | Table 3 — Extra wide flange beams HL and HLZ |
| 20 | Table 4 — Wide flange columns HD |
| 21 | Table 5 — Wide flange bearing piles HP |
| 23 | Table 6 — Wide flange bearing piles UBP |
| 24 | Table 7 — Universal beams UB |
| 27 | Table 8 — Universal columns UC |
| 29 | Table 9 — Taper flange I sections IPN |
| 30 | Table 10 — Taper flange I sections J Table 11 — Parallel flange channels UPE |
| 31 | Table 12 — Parallel flange channels PFC |
| 32 | Table 13 — Taper flange channels UPN |
| 33 | Table 14 — Taper flange channels U Table 15 — Taper flange channels CH |
| 34 | Annex A (informative) Comparison of symbols used in this document with those in EN 1993-1-1 Table A.1 — Comparison with the symbols used in EN 1993–1–1 |
| 35 | Bibliography |
